I installed an HC-05 in my 0.5.4 MicroRusefi
I issued the following command via the Rusefi console
Code: Select all
bluetooth_hc06 38400 rusefi 1234
Code: Select all
[code]
2022-07-17_16_01_11_850: EngineState: confirmation_bluetooth_hc06 38400 rusefi 1234:32
2022-07-17_16_01_11_850: EngineState: *** Bluetooth module setup procedure ***
2022-07-17_16_01_11_850: EngineState: !Warning! Please make sure you're not currently using the BT module for communication (not paired)!
2022-07-17_16_01_11_865: EngineState: TO START THE PROCEDURE: PLEASE DISCONNECT YOUR PC COM-PORT FROM THE BOARD NOW!
2022-07-17_16_01_11_865: EngineState: After that please don't turn off the board power and wait for ~15 seconds to complete. Then reconnect to the board!
2022-07-17_16_01_12_068: EngineState: Sleeping...
Here's my question:
In the 20220702 firmware, has bluetooth logic been disabled due the needing the pins for the SD card functionality? LINK to code reference.
If so, do I just need to rebuild the firmware with specific flags set to fix everything?
Board: MRE 0.5.4
Firmware: 220702
Bluetooth: HC06 via Amazon
Wiring
HC06(TX)-> RusEfi(J12) PB11
HC06(RX)->RusEfi(J13) PB10
HC06(VCC) -> RusEfi(5V)
HC06(GND)-> RusEfi(Gnd)
Reference information:
https://rusefi.com/forum/viewtopic.php?p=37473
https://rusefi.com/forum/viewtopic.php?t=828
https://rusefi.com/forum/viewtopic.php?f=4&t=340