Search found 219 matches

by bill
Mon Mar 27, 2023 6:27 pm
Forum: You and your build
Topic: BMW N73 Test Mule run on Stutska Dyno
Replies: 10
Views: 6963

Re: BMW N73 Test Mule run on Stutska Dyno

you do not need ITB's... the valvetronic will serve that function Nobody NEEDS ITBs and yet everyone needs ITBs :D They look cool .and have impedance injectors ss plug the GDI holes and move on. On the valvetronic I'd be very temped to find a way to lock it out of service and be done with it, at le...
by bill
Sun Mar 26, 2023 1:21 am
Forum: You and your build
Topic: BMW N73 Test Mule run on Stutska Dyno
Replies: 10
Views: 6963

Re: BMW N73 Test Mule run on Stutska Dyno

where are you located? Germany?
are you sure there are no injectors? its really hard to pull them out ... somebody would have to work hard to get them out
by bill
Sun Mar 26, 2023 1:06 am
Forum: You and your build
Topic: BMW N73 Test Mule run on Stutska Dyno
Replies: 10
Views: 6963

Re: BMW N73 Test Mule run on Stutska Dyno

I have just the engine - no intake manifolds, no exhaust manifolds, no fuel system and a bunch of damaged and missing sensors. It was a used take out that was stored for years and never used. I am looking into ITB setup i currently own and attempt to drive one of those pieces of shit 760iL worst ca...
by bill
Sat Feb 04, 2023 1:01 am
Forum: You and your build
Topic: Pps not reading in Tunerstudio
Replies: 52
Views: 18965

Re: Pps not reading in Tunerstudio

Slim804 wrote:
Sat Feb 04, 2023 12:18 am
When I put the multimeter on the wires, I'm getting 2.38 on the primary at full throttle and 4.68 on the secondary at full throttle
sounds correct.
and around 0.5V on each when the pedal is at idle?
by bill
Sat Feb 04, 2023 12:10 am
Forum: You and your build
Topic: Pps not reading in Tunerstudio
Replies: 52
Views: 18965

Re: Pps not reading in Tunerstudio

when you put the voltmeter on the signal wires from the pedal
with 5V and ground supplied to pedal
and move the pedal up and down
what are the voltages output on the wires?
0.5 to 3.5V on one output?
and
4.5 to 0.5 V on the second output?
that is normal for most bosch units
by bill
Fri Jul 15, 2022 3:22 pm
Forum: You and your build
Topic: BMW 760Li and Angst
Replies: 12
Views: 11559

Re: BMW 760Li and Angst

Rear Sunroof drain on E66 the rear drains are located at the end of the unibody beam, in front of the rear wheel, facing inwards peel back the plastic wheel liner, and you can reach in and mess with it on the drivers side, passengers side has pipes around, but still can reach in and pull out the pla...
by bill
Sun Jul 10, 2022 1:02 pm
Forum: You and your build
Topic: BMW 760Li and Angst
Replies: 12
Views: 11559

Re: BMW 760Li and Angst

WARNING! Fix this on your E65 E66 NOW. Before your dashboard turns into a christmas tree! The PT- CAN bus is a ribbon cable that runs from passenger footwell to the Emergency brake in the trunk. there are TWO places that are splices. 1-- under the left rear (drivers side) seat 2-- under the front pa...
by bill
Sun Jul 10, 2022 12:13 pm
Forum: You and your build
Topic: BMW 760Li and Angst
Replies: 12
Views: 11559

Re: BMW 760Li and Angst

for WinKFP, NCSexpert, INPA, etc VIN: WBAGN83525DKxxxxx ========== INPA: UIF (User Information Field) Report 1-Open INPA> select your car model (E65)> Functional Jobs> HIT -->F3 UIF 2-You'll see a list of all control units with their ZUSB number and VIN 4-Identify the ZUSB numbers without your VIN a...
by bill
Wed May 18, 2022 12:36 am
Forum: You and your build
Topic: BMW 760Li and Angst
Replies: 12
Views: 11559

Re: BMW 760Li and Angst

you can take the parking brake assembly out of the bmw 760li without taking out the rear air conditioner. also, you do NOT have to take off the parking brake assembly from the rear wheels.(like NewTIS tells you to do) open the parking brake actuator all the way to the "assembly mode" take ...
by bill
Fri May 13, 2022 4:42 pm
Forum: You and your build
Topic: BMW 760Li and Angst
Replies: 12
Views: 11559

Re: BMW 760Li and Angst

DONE... so far checked hplp for leaks checks pressure of low pressure and high pressure pumps cleaned carbon set cam timing tested evaporation valves 4 new injectors replaced 8 injectors cleaned and calibrated fixed steering leak with new pipe tran fluid 9 quarts and filter and gasket NEW --> 2 swin...
by bill
Fri May 13, 2022 4:22 pm
Forum: You and your build
Topic: BMW 760Li and Angst
Replies: 12
Views: 11559

Re: BMW 760Li and Angst

Zeiss wrote:
Tue Feb 15, 2022 7:33 pm
Outch, THIS means work..... a lot of work. This is a part of the chain tensioner, probably the tensioning bar....

Check this out: http://www.km5tz.com/BMW760iP5.htm
nice one!
by bill
Fri May 13, 2022 4:17 pm
Forum: You and your build
Topic: BMW 760Li and Angst
Replies: 12
Views: 11559

Re: BMW 760Li and Angst

i replaced the piston ring and dissecant
in the air pump for the air suspension
and it works much better now
pumps up the air springs in 30 sec instead of 5 minutes

https://www.ebay.com/itm/152579724686
s-l1600.jpg
s-l1600.jpg (176.87 KiB) Viewed 10628 times
by bill
Sun Apr 24, 2022 4:24 pm
Forum: You and your build
Topic: 2004 BMW 760 N73 "A big mistake"
Replies: 198
Views: 187416

Re: 2004 BMW 760 N73 "A big mistake"

my notes on install your machine may be different windows 10 ---------- ISTA put in the required stuff ( visual basic, etc ) shown on the readme just run the .EXE install and it works need 140 GIG hard drive and 4 GIG ram got to wrench icon and change the EDIBAS mode for the communication go to devi...
by bill
Sun Apr 24, 2022 4:20 pm
Forum: You and your build
Topic: 2004 BMW 760 N73 "A big mistake"
Replies: 198
Views: 187416

Re: 2004 BMW 760 N73 "A big mistake"

yessir, that pirate bay download will make your life easy...
by bill
Fri Apr 01, 2022 1:58 am
Forum: You and your build
Topic: NA Miata EcotecMiata Race Car
Replies: 68
Views: 48719

Re: NA Miata EcotecMiata Race Car

nice setup! any pictures of the engine/ drivetrain??
by bill
Thu Mar 03, 2022 12:12 am
Forum: You and your build
Topic: 2004 BMW 760 N73 "A big mistake"
Replies: 198
Views: 187416

Re: 2004 BMW 760 N73 "A big mistake"

useful shit for Electrical troubleshooting

https://e65club.com/?page_id=513
by bill
Tue Feb 22, 2022 7:19 pm
Forum: You and your build
Topic: 2004 BMW 760 N73 "A big mistake"
Replies: 198
Views: 187416

Re: 2004 BMW 760 N73 "A big mistake"

AndreyB wrote:
Sun Feb 20, 2022 3:47 am


Only I am not fixing this because unlike the video where they have easy access to the actuator I have Rear AC Blower Box + Roof AC Option + Fridge Refrigerator sitting on top of it.
you have the PIMPIN back seat... everybody needs a fridge in the back...
by bill
Thu Feb 17, 2022 2:33 pm
Forum: You and your build
Topic: 2004 BMW 760 N73 "A big mistake"
Replies: 198
Views: 187416

Re: 2004 BMW 760 N73 "A big mistake"

tranny fluid change needs a new pan/filter too-- like $60 plus the fluid is expensive ... and you only get a few quarts out by dropping the pan... it holds like 10 total in the tranny cooler, torque converter, etc and you need a special tool to pump out the remaining 8 quarts how much longer are you...
by bill
Wed Feb 16, 2022 11:49 pm
Forum: You and your build
Topic: Making my 190e More Fun (M111 Twincharged Swap) #57 [Hellen]
Replies: 103
Views: 84896

Re: Making my 190e More Fun (M111 SC Swap) #57

not important, but someday can you post a picture of the actual hardware for the SC, Bypass, Turbo, etc?
so we can put the drawing and physical setup together ...
by bill
Tue Feb 15, 2022 6:36 pm
Forum: You and your build
Topic: 2004 BMW 760 N73 "A big mistake"
Replies: 198
Views: 187416

Re: 2004 BMW 760 N73 "A big mistake"

I am trying to get 80% of the results at 20% the effort, after all I only need this car to last 500 more miles. I have too much random oil around my place I will put fresh oil into the car and drive it just for 50 miles and see what comes out. For better context let me really ask Bill to have a thr...
by bill
Tue Feb 15, 2022 4:49 pm
Forum: You and your build
Topic: BMW 760Li and Angst
Replies: 12
Views: 11559

Re: BMW 760Li and Angst

found this in the oil pan
probably a timing guide piece
means i get to go hunting !
My Joy Is Everlasting
IMG_20220207_121522493.jpg
IMG_20220207_121522493.jpg (328.99 KiB) Viewed 11490 times
IMG_20220207_121556829.jpg
IMG_20220207_121556829.jpg (321.63 KiB) Viewed 11490 times
IMG_20220207_121545195.jpg
IMG_20220207_121545195.jpg (241.98 KiB) Viewed 11490 times
by bill
Tue Feb 15, 2022 4:46 pm
Forum: You and your build
Topic: BMW 760Li and Angst
Replies: 12
Views: 11559

BMW 760Li and Angst

got a BMW 2005 760Li
similar to Andreys
its for the wife
and it has turned into a black hole of work.
39c73c5a50f84769bcf35203cc947b55_hrs.jpg
39c73c5a50f84769bcf35203cc947b55_hrs.jpg (286.25 KiB) Viewed 11491 times
by bill
Tue Feb 15, 2022 1:41 am
Forum: You and your build
Topic: 2004 BMW 760 N73 "A big mistake"
Replies: 198
Views: 187416

Re: 2004 BMW 760 N73 "A big mistake"

you are gonna WELD the diff?
that is pretty hardcore
dropping the rear subframe is a pain in the ass
i just did it

as the guy in the video said
"AAAGGHHH... i can't believe its finally out"
by bill
Sun Feb 13, 2022 12:22 am
Forum: You and your build
Topic: 2004 BMW 760 N73 "A big mistake"
Replies: 198
Views: 187416

Re: 2004 BMW 760 N73 "A big mistake"

"A lot of DSC/airbag/brake lights on the dash. Feels like power steering is not working." did you get that fixed? i bet your steering fluid is low check that fluid level. the DSC is run by the power steering pump. i had a mega leak in the lines. so it killed the steering and DSC when the f...
by bill
Sun Jan 02, 2022 1:06 am
Forum: Dev: Hardware
Topic: Ion Sense
Replies: 194
Views: 185023

Re: Ion Sense

sepp2gl wrote:
Sat Jan 01, 2022 9:21 pm

Yes I know, they used Melco-Coils in the later years.

looking forward to some interesting exchange
T2US, sepp2gl
Welcome Aboard!
Looking forward to your help ....
bill
by bill
Wed Dec 29, 2021 12:35 pm
Forum: You and your build
Topic: 2004 BMW 760 N73 "A big mistake"
Replies: 198
Views: 187416

Re: 2004 BMW 760 N73 "A big mistake"

AndreyB wrote:
Wed Dec 29, 2021 5:54 am
E65 does not have CAN on OBD port so I had to solder a custom PT-CAN CAN-enabled OBD port :)
details? how to do that?
:?:
by bill
Sat Nov 27, 2021 1:25 am
Forum: You and your build
Topic: BMW M70 in 8 series with Proteus?
Replies: 78
Views: 47518

Re: BMW M70 in 8 series with Proteus?

this is what i use... LS coils on my M73
image-1.png
image-1.png (335.2 KiB) Viewed 9735 times
by bill
Sat Nov 06, 2021 12:51 pm
Forum: You and your build
Topic: Greetings...
Replies: 11
Views: 5998

Re: Greetings...

Well I don't have any actual hardware yet, but I decided to start working on the software side of RusEFI. A little about my car: I decided to transplant a new-ish motor (BMW N20, turbo 4-cyl GDI) into an old-ish car (BMW E46). do you have some pictures of the car? and engine? i have a VEE12 bmw, th...