The firmware installed on the stm32 is from the na6 files. Then the jumpers make it compatible with the na8. Is this correct?
I’ve sat on this board for a while and I’m trying to dive back in. Hope this is the right place for this question.
Thank you
Search found 5 matches
- Wed Apr 07, 2021 11:37 pm
- Forum: Dev: Software
- Topic: Frankenso pnp with jumpers for 94-95 Miata
- Replies: 2
- Views: 2440
- Fri Aug 21, 2020 2:21 am
- Forum: Dev: Software
- Topic: Critical error: Pin "PA0" continued from github
- Replies: 8
- Views: 4871
Re: Critical error: Pin "PA0" continued from github
Yea I've got it set to none, everything is good now so far. I feel a bit like moron for this thread, but I appreciate the help from both of you
- Fri Aug 21, 2020 2:15 am
- Forum: Dev: Software
- Topic: Critical error: Pin "PA0" continued from github
- Replies: 8
- Views: 4871
Re: Critical error: Pin "PA0" continued from github
Here is what I'm currently looking at:
- Fri Aug 21, 2020 2:02 am
- Forum: Dev: Software
- Topic: Critical error: Pin "PA0" continued from github
- Replies: 8
- Views: 4871
Re: Critical error: Pin "PA0" continued from github
Okay I changed that and now the "Acc Pedal2" is set to the same thing. I'm going to go through and see how many more are assigned to PA0. I'll update you in a bit. Thank you for your help.
- Fri Aug 21, 2020 1:45 am
- Forum: Dev: Software
- Topic: Critical error: Pin "PA0" continued from github
- Replies: 8
- Views: 4871
Critical error: Pin "PA0" continued from github
Just to recall whats already been said I was following along with the software guide provided here and I started up the console to this message: EngineState: CRITICAL error: Pin "PA0" required by "TPS 1 Secondary" but is used by "MAF" 20200820@frankensoNA6 The logs cont...