rusefi.com

2021-04-18_13_29_22_938: EngineState: TRG rpm=0 time=645 index=0: gap=1.023 expected from 1.710 to 2.849 error=No 2021-04-18_13_29_22_939: EngineState: TRG duty 0.000000000 17947310 2021-04-18_13_29_22_939: EngineState: TRG rpm=0 time=645 index=0: gap=1.005 expected from 1.710 to 2.849 error=No 202...

I think I'm trapped. Now what do I need to do next

I have uploaded the tune，I believe that the problem will be solved soon

https://rusefi.com/online/view.php?msq=487

I think it should be the setup problem of the tuner Studio software. When I run the software, I disconnect the power supply of the device and find that the settings have not changed. However, after I quit the software, I will be prompted that the current configuration conflicts with the previous con...

The wire turnover of VR sensor has been tried, and the trigger signal has not changed. I still haven't solved the problem of unsaved settings. I have to reset them after power failure. This is my tuning file

2021-04-12_10_45_19_875: EngineState: *** rusEFI LLC (c) 2012-2021. All rights reserved. 2021-04-12_10_45_19_876: EngineState: *** rusEFI v20210411@28917 2021-04-12_10_45_19_877: EngineState: *** Chibios Kernel: 6.1.3 2021-04-12_10_45_19_877: EngineState: *** Compiled: Apr 11 2021 - 03:36:47 2021-04...

2021-04-12_09_17_59_450: ConsoleUI: COMPOSITE_OFF_RPM=300 2021-04-12_09_18_01_189: EngineState: initHardware() 2021-04-12_09_18_01_190: EngineState: led: CRITICAL status on PE3 2021-04-12_09_18_01_190: EngineState: initRtc() 2021-04-12_09_18_01_191: EngineState: engine chart: No 2021-04-12_09_18_01_...

After I tried many times, starting RPM still didn't respond, and the trigger waveform was consistent. The latest firmware has been updated. But it has to be reset every time there is a power failure

I have updated the firmware and used the trigger mode, but the startup rpm is still 0, and I found that TDC is behind the long teeth, but not before. Does the startup RPM display have anything to do with TDC?

ok, thank you very much

One of the teeth on the trigger wheel is long，TDC is located behind this tooth

Yes, the trigger mode is VR sensor

This is a kx450 engine. I plan to refit it on my motorcycle. This is a picture of the trigger wheel

This is an 18 tooth crankshaft. The starting RPM shows 0