1. Yes those two stay highlighted in blue
2. I set those same settings and "clutch down" stay highlighted in yellow
Search found 6 matches
- Thu Apr 07, 2022 8:48 pm
- Forum: Tuning Support: Making it Run
- Topic: NA6 AC and Clutch switch Function
- Replies: 2
- Views: 3123
- Sun Mar 27, 2022 9:04 pm
- Forum: Tuning Support: Making it Run
- Topic: NA6 AC and Clutch switch Function
- Replies: 2
- Views: 3123
NA6 AC and Clutch switch Function
This is a two part issue I am working on. 1. AC: I've compared my tune to another that has AC and this is what I have set for my AC settings. Screenshot 2022-03-27 155737.png With these settings the ac compressor stays engaged no matter what setting I have on my HVAC panel in the car, even if the bl...
- Sun Mar 27, 2022 8:43 pm
- Forum: Tuning Support: Making it Run
- Topic: NA6 Miata Dies After Cranking
- Replies: 5
- Views: 4789
Re: NA6 Miata Dies After Cranking
I meant to come back and post my fix but it has slipped my mind.
My issue ended up being that I did not have my fuel pump correctly jumpered at my AFM connector. I found the correct jumper configuration here under "wiring the peripherals" https://trubokitty.com/#/installation
My issue ended up being that I did not have my fuel pump correctly jumpered at my AFM connector. I found the correct jumper configuration here under "wiring the peripherals" https://trubokitty.com/#/installation
- Sat Nov 27, 2021 9:06 pm
- Forum: Tuning Support: Making it Run
- Topic: NA6 Miata Dies After Cranking
- Replies: 5
- Views: 4789
Re: NA6 Miata Dies After Cranking
Thank you for the good detail! I don't see anything immediately wrong with the tune or log. Are you still running the stock injectors? If so, I assume the car still runs properly on the factory ECU? Yeah, it's still on stock injectors and it ran fine before I pulled the stock ECU. The only note wor...
- Sat Nov 27, 2021 8:15 pm
- Forum: Tuning Support: Making it Run
- Topic: NA6 Miata Dies After Cranking
- Replies: 5
- Views: 4789
NA6 Miata Dies After Cranking
Hello everyone, I'm very new to the tuning world and I'm having issues with keeping my car running after it cranks. I can get it to catch and idle for about two seconds before it dies out and I am unable to keep it alive with the throttle. I have tried comparing my cranking, base engine, and idle se...
- Tue Nov 16, 2021 2:33 am
- Forum: Plug In Boards
- Topic: NA6 board communication issues with Mac
- Replies: 7
- Views: 12978
NA6 board communication issues with Mac
I have a Hellen NA6 board for my 91 Miata. Before installing the board into the car I went through the steps on the set-up guide to have the board talk with TS. I successfully established communication between the board and TS. Once I installed the board in the car I started TS before cranking to te...