rusefi.com

i hope not but i will check

also im facing an issue two brand new sensors on a a proteus reads backwards !

it sits at 10.0 afr at free air and when i hit it with butane it goes to 29

is there any prebuilt binary that will run the module and carrier as a standalone without the need of rusefi ?

i got 3 pieces here laying around and i would love to use them on my Dyno ( yourdyno ) or some Ms based ecus i have spare

so... with an stlink it uploads fine and it works ... no idea why it wont work via DFU

the best i managed to to is to get an error from stm qube 22:16:51 : Download in Progress: 22:16:52 : Error: Write failed at address: 0x8001800 22:16:52 : Error: failed to download Segment[0] 22:16:52 : Error: failed to download the File and the wideband flashes the leds quickly when powered up and ...

so i got 5 of them made https://github.com/mck1117/wideband/tree/master/hardware/board_module/export/rev%20B
but im stuck with the firmware im not able to find the binary for the modules in order to upload it on them am i missing something ? or i am that blind ?

https://kptronics.gr/

https://www.facebook.com/kptronics/

Athens Greece

setting the trigger type to Mazda SOCH 4
reads rpm on cranking with out sync loss

i havet started the car yet still need to modify the intake to fit the injector rail and make a turbo manifold for it

cant install a new injector unfortunately its a single point throttle body injector


the idea is to run it as is just to see that everything works
and then fit a saxo fuel rail that seems like it fits and convert it to port injection and slap a turbo on it

i was under the impression that it needs a peak and hold driver

also any easy way to drive the injector ?

its a Low z type 8ohms as autodata says

is the dissy trigger patter supported ? What trigger pattern? Need more info :) from what i can understand its an even 4 pulse trigger probably a 5v hall sensor looks easy to modify and put a 24-1 in and run it as a missing tooth cam speed if this one is not supported all the wires i scoped tho i c...

usually before tuning car we check ignition with timing and check if trigger wheel decoding correctly?! :D Who tuned what ? ;) all i did is throw the car on the Dyno ... plus i tune cars for living so dont worry about it all i asked if ithas been done allready is the dissy trigger patter supported ...

So here i am :) just got a vitara 1.6 8v TBI ( fitted with lpg too ! ) and 3 days in my possession it i already put it on the dyno made a whopping 50 wheel hp and 89 NM wheel torque :lol: :lol: here is a video of the dyno https://fb.watch/eUYox4VTaP/ and the dyno sheet https://scontent-sof1-1.xx.fbc...

new post with new info site is up

hi Panos from Athens Greece

this proteus is missing its mcu yet ( still waiting for it to be delivered )

but yes it will run Rusefi probably on my Z1000 turbo just to get to know the firmware

i will start a new thread when i have it up and running for sure

i got my usb for the Proteus case and i didnt realize that it comes without a cap on UB-20PMFP-LC7002 so i made one

use an oring inside and it should be waterproof
https://www.thingiverse.com/thing:5248219