rusefi.com

thanks

Thanks

Hi, I've wired up temp VSS signal from the dash. I have confirmed that the dash output is 5 volts when high, and 0 volts when low, and that it switches state as the car moves. I have hooked the wire up to 1M, VSS input, I have configured tuner studio to use 1M as VSS input, but I cannot see a vehicl...

The socialist utopia of New Xiland (formally known as the great country of New Zealand), Bay of Plenty

Thanks

Hi, I've searched the forum, but couldn't find anything relatively recent on GPS use. I see that there is a vehicle speed setting for throttle off fuel cut, but the car does not have a VSS sensor in the dash (91 manual 1.6). I'd like to add the option of disabling this function if the car is under a...

Good spotting batman! I completely missed the % and read it as RPM as above. That kinda makes sense why it could have been switching to the coast down table, (even if i had changed to openloop and had assumed it was no longer in use.)

I made some changes back to more stable figures within Idle control. noticed a couple of interesting things. 1. the idle up that I had noticed wasn't AC, but fan 1, obviously, becuase AC turns Fan1 on, I hadn't noticed the less obvious connection. When testing the Fan1 output from the base engine ta...

Hi guys, please forgive my upload for Sharron's roadster, I have a bit of a question around idle up of the AC. I have been reading the idle explanation and I can see that I still have a bit of work to do around tuning that. So tonight I went out and tried to hunt down the issue of why the car rocket...

re-pined to original, values are now backwards, but all errors are cleared. car starts, smell rich and rough, Hi idle (1400) and dies after a few seconds. So i guess I'm on the right track. thanks

I'll repin back to original, I wasn't getting a reading before. will try starting again with fresh project. Thanks

Hi, I'm having an issue with the TPS on a 91 Miata, I've recently purchased a 91 PNP hellen rev B unit. I have swapped out the TPS for a Kia unit,I have moved the pins around on the TPS connector and managed to calibrate the TPS thru TS tools. The values I get are ball park, foot off 260, foot on, 9...