rusefi.com

Thanks Will do

May I have found it :shock: Capture 11.PNG I swapped the cam and crank inputs I now get this in the trigger logger Capture 10.PNG It seems weird because the CKP is connected to pin 1 of the small black connector and the Cam to pin 2 of the small black connector Apparently I am a MORON ---- I should ...

Hi Andrey, I was hoping to get this Capture 3.PNG I assume the green line is the CAM and the blue is the crank. I get this when I use the ECU simulator option in TS. I want to get this working with the bench crank cam simulator. I suspect there is a issue with the car and I am trying to eliminate th...

Hi folks, This is making my brain hurt!! I have Proteus ECU and have wired it to run a Mazda 1.3 Skyactiv, well thats is the plan. Initially I had a issue with NO crank and cam triggers. After closer inspection the cam and crank have the same plugs but run difirrent sensors, I have sorted the wiring...

Hi Team,
Finnaly managed to circle back to this install...
It seems that I have a new issue now. I was wondering if Mk1117 might be able to share the manual with me Pretty Please

1. please wait at least 33 minutes to let system build new snapshot with https://github.com/rusefi/rusefi/commit/ca4936d3fe85b4e78b8471ed2217692a7fd4bc9c fix 2. please update firmware and update project definition 3. please set 60/2 crank and mazda skyactiv cam mode on advanced trigger 4. please pr...

I used the ecu stimulator to get a idle speed then used diagnostic high speed loggers to capture the screen shot. I noticed that there is no 60-2 crank pattern but rather the cam pattern and in the what would be the cam patters is a single tooth pattern. I am the new guy here and likley have thing w...

I have up loaded the new firmware and must have done something right :o It now works no errors, dont know why. Recon because I started a new project in TS might have helped. The interesting thing is this it seems that the "mystery Mazda" option places the cam signal on the crank. The crank...

I have uploaded a tune that sort of works, but it is on the older firmware.
This tune does not have the skyactiv option.

OK well that was a long night. The issue seemes to be only isolated to the new firmware "20220831_023949_proteus_f4_rusefi" this one has the "mystery Mazda" option. If i restore the firmare to a earlier one it functions again, go figure..... I have no idea on how to fix this. :ge...

I dont get any errors like yours.

I did make a new project and I now get this error. Wonder if the new firmware is the issue?

Hi I think i found something....

Might be this INI file error?


121 Warnings:
see the TXT file attached

Hi MHTSOS,

I get no errors when I connect TS.

Hi Andrey, Sorry new guy here. I got the new firmware installed, eventually. My brain still a little lost. I have also found where you have put the "mystery Mazda". Does this setting allow for a 60-2 Crank and Special Mazda cam signal? I also now have a critical error this is new, how can ...

Hi Andrey,

As far as I know its a 2014 Mazda 2 Skyactive 1.3 petrol. I only have the engine and not the vehicle. Thanks for the updated camwheel. insidently the exhaust cam has the same pattern. I Didi not remove the cam cover to see the tone wheel.

Ray

Hi peoples, I have a triky one and I am looking for help. The vehicle I am using has a mazda skyactive engine and I need to sync the injectors. The crank uses a 60-2 hall effect signal and the Cam is a odd one The yellow trace is the Inlet cam, the blue is cylinder 1 coil events so that I could get ...