rusefi.com

Ok found what I am going to do since I have some CJ125 chips from a separate project I was going to do. I have ordered some boards for the cj125 module hardware section: https://github.com/rusefi/hw_modular/tree/master/cj125_Module They are on order from JLCPCB this way I will setup a left and right...

Just getting back to this project; so, I have a wideband O2 sensor that I will be hooking up to the Proteus as shown before in previous posts. I have not seen much on how to hook this up to the board. Any suggestions and links would be greatly appreciated!!! Just starting to research how to hook thi...

Ordered 5 to start. I had to order some of the ic's off ebay since there was no other source available. IC's like Max9924 and BTS4175SGA had to be ordered out of ebay. i would be happy to buy one or two as pictured if you have any to sell I would be glad to sell you two at cost if you could test it...

Ordered 5 to start. I had to order some of the ic's off ebay since there was no other source available. IC's like Max9924 and BTS4175SGA had to be ordered out of ebay. i would be happy to buy one or two as pictured if you have any to sell mouser has Max9924 BTS4175SGA do you even need high current ...

Nice! How many proteus boards have you ordered? Ordered 5 to start. I had to order some of the ic's off ebay since there was no other source available. IC's like Max9924 and BTS4175SGA had to be ordered out of ebay. Hope they get here next month. I will start testing next week without the chips on ...

So, for now the reason I am not using smart LS ones is simply because I want to be able to swap back to Ford PCM if I want. Also, I did not want to pay for the LS coils at this time. IDK, kinda limiting the changes at this point. However, in the end I think LS coils will deliver the best results; s...

Got my boards early this week.

Below is my spreadsheet for the 4R70W transmission controller specs I have gleaned from Ford Manuals. https://drive.google.com/file/d/1F4l5n8EHLNwfdud-JFVzuOp5Jsn7Hiso/view?usp=sharing So, For Trans Temp It is important to note the I am going to consider the sensor linear between the ranges that I h...

So, for now the reason I am not using smart LS ones is simply because I want to be able to swap back to Ford PCM if I want. Also, I did not want to pay for the LS coils at this time. IDK, kinda limiting the changes at this point. However, in the end I think LS coils will deliver the best results; so...

Hello all, This is new thread based on the progress of my 1999 Ford F150 build that I am doing using a Proteus board. So I have submitted the proteus_0_7 gerber files to JLCPCB to get built. Main goal: Maintain existing wiring as much as possible. So, Proteus must be as PNP as possible. Looking at t...

Well, looky here you guys have already done the work! https://github.com/rusefi/rusefi/tree/master/hardware/Breakout_104pin_EEC-V-Connector Now, all I have to do is get the pins right for the F150 I will provide a spreadsheet with the pinout in github this week. Then figure out the ECU and PCM relat...

I would like to help with this build. I have a 1999 Ford that I have been messing with to get off the Ford ECU and have planned to use MegaSquirt to do this swap. However. I like would rather spend some time developing a PNP board for the 104 pin ECU controller. Here is my setup: 1999 Ford F150 with...