rusefi.com

Hello, you managed to make the successful connection of the bluetooth module, I am trying to make it in microrusefi 0.6.0 but I have not been able to
In advance I thank those who help me for their time.

very good afternoon, I am opening this topic so that you can guide me regarding a microRusEFI 0.6.0 board that I assembled I am already doing tests on an engine, I have a problem with the ign outputs or coil outputs, since they do not turn on, I have tried with a multimeter and placed the outputs, i...

Hello to all, I have been lurking and following for a few years. This will be my first post. I would like to say rusefi open source platform has been great for the diy tuning efi community. I have considered spinning rusefi board with pnp connector for obd1 honda. However most folks seem to be perf...

..as I see on first photo ... (probably) all OP-Amps has bad soldered pins .. some other IC also ... few resistors not looks so good.... ..probably too many problems on it.... :roll: solved, friends, it was actually a cold welding on a vbat resistance, the repair with the cautín and problem solved,...

AndreyB wrote:

diegort5 wrote: ↑

Sun Oct 15, 2023 1:55 pm

I ordered the board from jlpcb and the components from digikey

That's actually vague. Who has done what percentage of soldering? Is this 100% hand-soldered by you unit?

I tested the exits and entrances using ardustim, 100% assembled by my hands

Enviado desde mi Redmi Note 8T mediante Tapatalk

I manufactured it, I ordered the board from jlpcb and the components from digikey, I am an enthusiast of the motor world, I come from speeduino and now I want to know rusefi, I have already tested the functionality of this ecu and everything is fine except the voltage reading

Yes, I have tested 3.3v and 5v and it is fine, the only anomaly is the 12v voltage reading.

Hello, I assembled the microRusEFI myself, I attach a photo of the place where I connected the 12v

https://www.facebook.com/607657938/videos/199147859743018/ Hello, good afternoon everyone, I have a problem with my microRusEFI R6.0, when connecting 12v to the tunnerstudio the indicator gives 21.4v, which may be generating this fault. I listen to suggestions and I tried to look for the menu Base ...