rusefi.com

Hi ,what do you thniks about to port to the Aurix tricore 200mhz with generic timer module GTM for crank angle and free tool chain?
https://www.hitex.com/microcontroller-support/aurix/shieldbuddy-tc275/

Is this possible?

hi ,thanks, yes its 60/2 vr , the board is ready to test in my car, all circuit are tested (ign, inj, sensors and tach in). I can wait to replace headcam gasket .Unfortunately broke last week. the next week will be ready to start..

hi, this is 12volt source. i put in the fuse place for board test only

hello guys ,step by step, the tach imput is ready now ... i tested on a jimstim to generate 60-2 signal. the next step should be to check the analog imput and ignition/injection output.
here a picture of my board:

yeahhhhhh i put a 10k pot and works great...

[video][/video]

thanks! a small tiny potentiometer is a good idea , i try other resistor value

hi, i try which 2k and 1k now.

thanks russian TS work perfect!!!

yes i use soldering paste, its the best method.

i'll try....

hi guys , after a long wait finally I have the frankenso board in my hands :D :D and I started welding work. -the board power supply work fine, tested. -load the firmware successful in the smt32 board. -the rusefi console connection work. but i have many questions, whats it is the communication port...

hi friends, when is 2.0 board for sale? i see that testing now :D i want order now. i think to order 1.0 but i prefer wait to release Thank you for your interest! There would be no 1.0 or 2.0 until 2018 probably, but there are the green 0.1 and red 0.2 :) Right now I have exactly one bare board or ...

hi friends, when is 2.0 board for sale? i see that testing now i want order now. i think to order 1.0 but i prefer wait to release

russian wrote:

juanj wrote:the kit come with all cap, resistor and other necessary items?

Nope, you need a bag of 0805 separately - http://rusefi.com/forum/viewtopic.php?f=4&t=212&start=30#p11388

perfect!!

thanks russian and kb1gtt, I begin to read the wiki, i plan to order the Frankenso DIY 0.1 parts kit and stm32f4discovery brain board on tindie shop, i question, the kit come with all cap, resistor and other necessary items?

Hi,sorry my english ins't good.
I am a Efi enthusiast and i read the forum several months ago,I think you are doing a good job, I installed megasquirt and other stand alone engine magnament, I am interested at run a Frankenso in my Opel corsa, I hope to learn in this forum.
thanks