rusefi.com

Nice.

You are getting old .

100kpa @ stoped engine and maybe 50kpa @ 10k rpm?

Need calibrate my map sensor. How can i get the specs of it? There's a easy way?

[video][/video]

Working.

because my engine only have one cylinder and the map signal isn't constante, it´s like a wave. Wait a second, this is taken care of! You do not need to worry about the wave. It is also a wave for a 4 cylinder, that's why we have MAP sampling start angle and MAP sampling window angle, and then we av...

puff wrote:if you do a tps setup, could you please record a screencast? or just a brief tutorial?

Maybe i will do it by tps, because my engine only have one cylinder and the map signal isn't constante, it´s like a wave. I think will be hard tune it with map sensor.

russian wrote:Looks like we are getting closer

What is your plan for sensors? What are all sensors you have and what are you going to use for engine load - TPS/MAF/MAP?

We can trie map or tps.

Injector is pulsing

VR input works!
Now I need to count how many small teeth I have after the wide tooth.

Thanks, tomorow morning i will test it.

Engine closed and working with carburator. Next step, fit itb.

[video][/video]

I fail to see why polarity is all that important of a concern. I understand it is important if you don't have control over whether the software triggers on raising or failing edge. However rusEFI has that ability. If the polarity is flipped, all that happens is the software will need to trigger on ...

Yes, but how can i know if the signal is positive or negative? I can´t see it without scope.

Hi, how can i know vr sensor polarity? I know if i connect it to a scope "in positive mode" i have one wave, if i change the wires i have another wave (like a mirror). How to know which pin is the right one to conect it to crk2+ without using a scope?

Vr sensor

russian wrote:

puff wrote:so, now the most interesting part - will it be implemented in two-wire or four-wire logic?

Right now I am implementing a two-wire setup simply because someone has donated the hardware and I can focus of the software.

4 wires please

This's to check the starter motor only. The engine it's without cilinder head, need adjust head compression to this piston.

First video

[video][/video]

One more step, still waiting for parts. https://dl.dropboxusercontent.com/u/33323872/Motas/Sachs/Minha/Motor/20141202_210409.jpg https://dl.dropboxusercontent.com/u/33323872/Motas/Sachs/Minha/Motor/20141202_210326.jpg https://dl.dropboxusercontent.com/u/33323872/Motas/Sachs/Minha/Motor/20141202_2103...

Smd resistores and capacitores.

Arrived

I´m waiting for parts, maybe +15 days.

My Frank board isn't ready to test.

Trigger wheel and sensor.

Very good.

In progress

Engine


rusefi

Bem vindo ao grupo.

Hope she said " oh beautiful bike ".

Ready to fit the engine