rusefi.com

OSH park had an issue with my boards, so instead of them replacing them i just "repaired" the ones i got. There was no connection to GND at C1.

OK, long story short. Tacho output set to PD11 gives the FATAL error led...

Somehow I can't replicate the dead comm's fault at the moment. But I will keep trying

OK, a couple of good tries later... The 20160706_2358 build works OK without the firmware FATAL error. I have a couple of LCD's here, but i can't seem to get the 20x4 to work... "the 128x64 doesn't work either, just had to try..." No, unfortunately I don't have the Discovery board. Althoug...

Hi, yes I usually end up taking the hardest route on everything unfortunately. Latest meaning probably two-three weeks old? Same .ini in tunerstudio.

Unfortunately the console will not connect once the firmware fatal is present.

I will try an older firmware and check

Hi there, Just got my rusefi board soldered together and firmware loaded via SWD. However Once I have connected Tunerstudio @ baud 38400 PC10/11, it works fine. Until I change any setting and hit burn, it automatically disconnects. If i reconnect without resetting the board it start right back up ag...

Plans for the BMW M70B50 v12 engine, hopefully full sequential setup and turbos :) Going for the Toyota/Denso 90919-02230 Coils btw. I saw the TunerStudio config file, should have looked before asking :roll: Sorry :oops: Another thing. Is the "bits" hardcoded, or can i change the display n...

Hi there,

Is it much work to add 4 more Ignition outputs in the software? Instead of 8, I would like 12
And yes, Dual IGN/INJ Table would be nice too. Just add a Table Switch function

Regards from Norway!