Search found 37 matches
- Sun Oct 02, 2016 5:38 pm
- Forum: Dev: Software
- Topic: Firmware issues?
- Replies: 18
- Views: 12732
Re: Firmware issues?
OSH park had an issue with my boards, so instead of them replacing them i just "repaired" the ones i got. There was no connection to GND at C1.
- Sun Oct 02, 2016 4:54 pm
- Forum: Dev: Software
- Topic: Firmware issues?
- Replies: 18
- Views: 12732
Re: Firmware issues?
OK, long story short. Tacho output set to PD11 gives the FATAL error led...
Somehow I can't replicate the dead comm's fault at the moment. But I will keep trying
Somehow I can't replicate the dead comm's fault at the moment. But I will keep trying
- Sun Oct 02, 2016 2:48 pm
- Forum: Dev: Software
- Topic: Firmware issues?
- Replies: 18
- Views: 12732
Re: Firmware issues?
OK, a couple of good tries later... The 20160706_2358 build works OK without the firmware FATAL error. I have a couple of LCD's here, but i can't seem to get the 20x4 to work... "the 128x64 doesn't work either, just had to try..." No, unfortunately I don't have the Discovery board. Althoug...
- Sun Oct 02, 2016 1:37 pm
- Forum: Dev: Software
- Topic: Firmware issues?
- Replies: 18
- Views: 12732
Re: Firmware issues?
Hi, yes I usually end up taking the hardest route on everything unfortunately. Latest meaning probably two-three weeks old? Same .ini in tunerstudio.
Unfortunately the console will not connect once the firmware fatal is present.
I will try an older firmware and check
Unfortunately the console will not connect once the firmware fatal is present.
I will try an older firmware and check
- Sun Oct 02, 2016 1:03 pm
- Forum: Dev: Software
- Topic: Firmware issues?
- Replies: 18
- Views: 12732
Firmware issues?
Hi there, Just got my rusefi board soldered together and firmware loaded via SWD. However Once I have connected Tunerstudio @ baud 38400 PC10/11, it works fine. Until I change any setting and hit burn, it automatically disconnects. If i reconnect without resetting the board it start right back up ag...
- Sun Sep 04, 2016 9:43 pm
- Forum: Dev: Software
- Topic: Adding more ignition outputs to software.
- Replies: 3
- Views: 3296
Re: Adding more ignition outputs to software.
Plans for the BMW M70B50 v12 engine, hopefully full sequential setup and turbos :) Going for the Toyota/Denso 90919-02230 Coils btw. I saw the TunerStudio config file, should have looked before asking :roll: Sorry :oops: Another thing. Is the "bits" hardcoded, or can i change the display n...
- Sun Sep 04, 2016 6:10 pm
- Forum: Dev: Software
- Topic: Adding more ignition outputs to software.
- Replies: 3
- Views: 3296
Adding more ignition outputs to software.
Hi there,
Is it much work to add 4 more Ignition outputs in the software? Instead of 8, I would like 12
And yes, Dual IGN/INJ Table would be nice too. Just add a Table Switch function
Regards from Norway!
Is it much work to add 4 more Ignition outputs in the software? Instead of 8, I would like 12
And yes, Dual IGN/INJ Table would be nice too. Just add a Table Switch function
Regards from Norway!