Troubleshooting: setting up the board with pre-compiled code
Posted: Tue Jan 07, 2014 3:24 am
I have finally started playing with my STM32, and I've run into some questions and as others come along they may have the same problems. So I'll start by asking my questions here.
I have successfully installed ST-Link utility and followed the writeup here: http://rusefi.com/forum/viewtopic.php?f=5&t=283
First I played with the original (pre-installed) program a little (using the STM32 as a "mouse") then followed the writeup. It connected and after programing using the rusefi.hex file I reset the board and it went back to flashing all the LEDs like it had before. I re-checked things and tried again - same thing. So I tried erasing the board and that was successful (no more flashing LEDs). So I tried re-programing again and it didn't change anything. I must be missing something - any ideas what I should try next?
I have successfully installed ST-Link utility and followed the writeup here: http://rusefi.com/forum/viewtopic.php?f=5&t=283
First I played with the original (pre-installed) program a little (using the STM32 as a "mouse") then followed the writeup. It connected and after programing using the rusefi.hex file I reset the board and it went back to flashing all the LEDs like it had before. I re-checked things and tried again - same thing. So I tried erasing the board and that was successful (no more flashing LEDs). So I tried re-programing again and it didn't change anything. I must be missing something - any ideas what I should try next?