RusEFI wideband controller. Making it run

Tuning, troubleshooting and the nitty gritty of using rusEFI to make your engine run nicely!
Post Reply
Kavabanga
Posts: 58
Joined: Sat Apr 13, 2019 9:07 pm

RusEFI wideband controller. Making it run

Post by Kavabanga »

Hi!
I ordered RusEFI WBO controllers on JLCPCB, programed them, connected one of them to an LSU 4.9.,to +12v and to my Frankenso. Everything was great, sensor was pre-heated by the controller and green LED showed me that everything is OK by slow blinking.
But my AFR gauge in the TS shows 0... As I know, if I have a sensor on the open air (and I have my sensor on the open air now), gauge must show BIG AFR values.
What do I need to make my gauge work in the TS?

Probably, my tune is wrong.. Here is the link:
https://rusefi.com/online/view.php?msq=496
Kavabanga
Posts: 58
Joined: Sat Apr 13, 2019 9:07 pm

Re: RusEFI wideband controller. Making it run

Post by Kavabanga »

I made it work
Just was needed to put "true" in Enable AEM X-Series CANbus :)
Post Reply