Malfunctioning Frankenso board.

From Frankenstein to Proteus and everything in between
Post Reply
paragj
Posts: 9
Joined: Sun Jul 18, 2021 9:43 pm

Malfunctioning Frankenso board.

Post by paragj »

Hello fellow rusEFI-ers,

BLOT
I have a Frankenso-based ECU (~3-4 years old) that I have built a Hardware-in-loop rig with. Of late, some of the pins on the board are acting as 5V outputs when they should not be.

Details
I have a Frankenso-board ECU that some of you may recognize (photo attached: FrankensoBoard.jpg).
FrankensoBoard.jpg
FrankensoBoard.jpg (4.36 MiB) Viewed 2636 times
As per the schematic (file attached: frankenso_schematic (7).pdf), pin 3K is supposed to be at 5V- which I do see. However, for some reason, pins 3L and 3Q are at ~5V too (see attached Frankenso_part.png).
Frankenso_part.png
Frankenso_part.png (136.63 KiB) Viewed 2636 times
I configured these pins to be outputs (to an ETB). I have uploaded the latest tune here: https://rusefi.com/online/view.php?msq=623.

Any ideas to debug this further are highly appreciated!

Regards,
Parag
Attachments
frankenso_schematic (7).pdf
(481.51 KiB) Downloaded 141 times
User avatar
AndreyB
Site Admin
Posts: 14292
Joined: Wed Aug 28, 2013 1:28 am
Location: Jersey City
Github Username: rusefillc
Slack: Andrey B

Re: Malfunctioning Frankenso board.

Post by AndreyB »

image.png
image.png (83.63 KiB) Viewed 2613 times
note pull-downs (horizontal) further up and pull-ups (vertical)

on the right we see mostly pull-ups right? That's one of the areas where boards were sometimes assembled not 100% according to schematics because of options and flexibility.
Very limited telepathic abilities - please post logs & tunes where appropriate - http://rusefi.com/s/questions

Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
User avatar
AndreyB
Site Admin
Posts: 14292
Joined: Wed Aug 28, 2013 1:28 am
Location: Jersey City
Github Username: rusefillc
Slack: Andrey B

Re: Malfunctioning Frankenso board.

Post by AndreyB »

pull-downs are 500K pull-ups are 10k usually

I suspect that you want to replace some of those

https://github.com/rusefi/rusefi/wiki/Hardware-Frankenso#analog-inputs could be helpful
Very limited telepathic abilities - please post logs & tunes where appropriate - http://rusefi.com/s/questions

Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
Post Reply