Page 3 of 3
Re: Basic / Trigger setting problem - little bit confused
Posted: Sun Mar 17, 2019 2:52 pm
by Simon@FutureProof
The 60-2 is a fairly standard Bosch trigger pattern used on most of the Motronic based systems, that means BMW from ~83 to present, VW, some AUDI and I believe some volvo and Alfa with Bosch management.
BMW sensors are VR like the VW engines up until about 1998 when they switched to Hall, so there is plenty of them out there with Hall.
Re: Basic / Trigger setting problem - little bit confused
Posted: Tue Mar 19, 2019 7:41 pm
by JRD McLAREN
..another one scope ..
Re: Basic / Trigger setting problem - little bit confused
Posted: Fri Apr 12, 2019 10:17 pm
by AndreyB
Did you end up with a running engine?
Re: Basic / Trigger setting problem - little bit confused
Posted: Fri Apr 12, 2019 10:21 pm
by JRD McLAREN
Yes, it run ..
I have some logged data ..
..and new frankenso board on my desk ..
It looks like a pretty fast ecu, with huge potential..
Re: Basic / Trigger setting problem - little bit confused
Posted: Fri Apr 12, 2019 10:26 pm
by AndreyB
JRD McLAREN wrote: ↑Fri Apr 12, 2019 10:21 pm
Yes, it run ..
Video or it never happened
Re: Basic / Trigger setting problem - little bit confused
Posted: Fri Apr 12, 2019 10:36 pm
by JRD McLAREN
russian wrote: ↑Fri Apr 12, 2019 10:26 pm
Video or it never happened
..you like this hint .. yes ..
Re: Basic / Trigger setting problem - little bit confused
Posted: Wed Oct 30, 2019 1:38 am
by AndreyB
Re: Basic / Trigger setting problem - little bit confused
Posted: Wed Oct 30, 2019 1:44 am
by AndreyB
@mck1117 said
a hall sensor engine will work fine with the VR config (ie, only decode one edge)
event every 6 degrees vs. event every 3 degrees isn't a difference, other than sucking up cpu cycles
new messages
whatever edge and type of sensor you have, if you see gap ratios of 1-1-1-2-2-1-1-1 instead of 1-1-1-3-1-1-1 then the polarity is wrong