Page 1 of 1

Hi from Poland

Posted: Sun Jul 07, 2019 3:40 pm
by dvjcodec
Kris from Poland onboard :)
Looking for DIY ECU solutions, designing own boards, etc.
Now I will try to run RueEFI firmware with my ECU board called SCG-ECU 1.0 and STM32F407. If everything will work prop, I will design new ECU for STM32F407 development board.

https://github.com/dvjcodec/SCG-ECU-1.0
http://www.aliexpress.com/item/32985219862.html

Re: Hi from Poland

Posted: Sun Jul 07, 2019 4:28 pm
by AndreyB
designed for speeduino? there must be a few gaps between speeduino and rusefi in terms of features. hopefully there is also at least one advantage but i have no idea to be honest :)

welcome to the forum! did you join slack for quicker chatting?

Re: Hi from Poland

Posted: Sun Jul 07, 2019 5:38 pm
by dvjcodec
Yes, this board designed for speeduino and Teensy 3.5, so all nececery electronic 3V3-->5V, power regulators already onboard. Schematic available on my github. I think to design cross-platform ECU mainboard to run Teensy 3.5 or STM32F407 for speeduino and rusEFI. Don't know yet is possible, but I hope so :) I will put new Topic when start to pinnign STM32.

Slack for quicker chatting? Where can I find it?

Re: Hi from Poland

Posted: Sun Jul 07, 2019 6:34 pm
by AndreyB
dvjcodec wrote:
Sun Jul 07, 2019 5:38 pm
Slack for quicker chatting? Where can I find it?
https://rusefi.com/forum/viewtopic.php?f=13&t=1198

Re: Hi from Poland

Posted: Sun Jul 07, 2019 7:45 pm
by kb1gtt
I see you put LED's on your board, and I'm a fan of that. Beware there are some in Slack land who do not like LED's.