A V-twin Hello from Russia
Posted: Wed May 20, 2020 12:40 pm
Another hello from Russia!
Sorry for my bad english.
I am also from a small town near Moscow. Because of the virus, I got a lot of free time. Just starting to deal with this project.
I want to convert my carburatur V-twin motorcycle into injector system. So for me its hardware + software project.
I am programmer for embedded systems, STM32 too - so I think I can figure out the software part of the project.
AndreyB, I am interrested in MicroRusEFI, I saw them in ebay. I correctly understand that in order to assemble and test the system on the table, I need a RusEFI board, sensors, nozzles, coils and spark plugs? I got factory made injection module, with throttle position and MAF sensor, idle control. There is a hall sensor on the motorcycle, but only for 2 crankshaft positions, so I need to increase the number of positions (to how many?).
Sorry for my bad english.
I am also from a small town near Moscow. Because of the virus, I got a lot of free time. Just starting to deal with this project.
I want to convert my carburatur V-twin motorcycle into injector system. So for me its hardware + software project.
I am programmer for embedded systems, STM32 too - so I think I can figure out the software part of the project.
AndreyB, I am interrested in MicroRusEFI, I saw them in ebay. I correctly understand that in order to assemble and test the system on the table, I need a RusEFI board, sensors, nozzles, coils and spark plugs? I got factory made injection module, with throttle position and MAF sensor, idle control. There is a hall sensor on the motorcycle, but only for 2 crankshaft positions, so I need to increase the number of positions (to how many?).