rusEFI Frankenso
Posted: Fri May 22, 2020 7:32 pm
Hello all. This is CK. I am new to this forum. I am looking to purchase rusEFI Frankenso standalone engine management system ECU set for miata mx-5 #333273429276 from Ebay.
My question is if this ecu when plugged into the factory wire harness start and run my Miata. I have a 91 Miata w/94 1.8L engine. Engine has Honda crb 600 carburetors instead of Fuel injection.
My son got the car like this Not running. Previous owner installed a hall effect distributor in it with a Crane Cams Fireball HI6DI2 multi spark ignition box, that he says was running. He cut up the wire harness and ran the car off toggle switches like a race car. Went to the junk yard and replaced the whole wire harness front to rear. I will replace distributor with factory Camshaft Sensor and coil packs. Keep carbs on with regulated stock fuel pump. Will the car start and run just by plugging in. How do I tune through ecu with laptop? Have never done that before. Thanks ahead for your replies.
My question is if this ecu when plugged into the factory wire harness start and run my Miata. I have a 91 Miata w/94 1.8L engine. Engine has Honda crb 600 carburetors instead of Fuel injection.
My son got the car like this Not running. Previous owner installed a hall effect distributor in it with a Crane Cams Fireball HI6DI2 multi spark ignition box, that he says was running. He cut up the wire harness and ran the car off toggle switches like a race car. Went to the junk yard and replaced the whole wire harness front to rear. I will replace distributor with factory Camshaft Sensor and coil packs. Keep carbs on with regulated stock fuel pump. Will the car start and run just by plugging in. How do I tune through ecu with laptop? Have never done that before. Thanks ahead for your replies.