[Success Story] 1996 Mazda Miata M Edition

Your chance to introduce yourself and your vehicle
Post Reply
ZHoob2004
contributor
contributor
Posts: 153
Joined: Sun Apr 03, 2016 7:11 pm
Location: Tucson, AZ

1996 Mazda Miata M Edition

Post by ZHoob2004 »

Under duress from @beermoneymotorsports I'm forced to make a build thread for the Miata project. Since the car is "finished" (lol) I'll be starting with that and a few highlights then maybe expand from there.

1996 Mazda Miata "M Edition"

1.8 with .020 overbore
Supertech pistons (9.5:1)
Manley rods
Wiseco rings
Boundary oil pump
ACL bearings
ARP studs
Kraken manifold and 3" exhaust
Pulsar GTX2871R
Bosch 68mm ETB
3bar TMAP sensor

Originally built with Proteus 0.3 using a homemade adapter harness
Currently running Hellen PNP for 1996 Miata from @beermoneymotorsports with microrusefi 0.1 as an additional sensor control module

There's a lot going on with this car, and I'm sure I've missed a lot so if anyone cares to know more let me know and I'll update the thread.
IMG_1714.jpg
IMG_1714.jpg (2.11 MiB) Viewed 2411 times
IMG_1746.jpg
IMG_1746.jpg (2.41 MiB) Viewed 2411 times
IMG_1747.jpg
IMG_1747.jpg (2.34 MiB) Viewed 2411 times
IMG_1749.jpg
IMG_1749.jpg (2.17 MiB) Viewed 2411 times
PXL_20211114_201648717.jpg
PXL_20211114_201648717.jpg (1.53 MiB) Viewed 2411 times
IMG_1750.jpg
IMG_1750.jpg (1.33 MiB) Viewed 2411 times
IMG_1773.jpg
IMG_1773.jpg (1.59 MiB) Viewed 2411 times
PXL_20211114_200723094.jpg
PXL_20211114_200723094.jpg (1.31 MiB) Viewed 2411 times
BeerMoneyMotorsports
Posts: 151
Joined: Thu Jan 14, 2021 10:16 pm

Re: 1996 Mazda Miata M Edition

Post by BeerMoneyMotorsports »

I really like that catch can setup and how the lines flow.
Post Reply