rusefi.com

After reading and updating rusEFI documentation I bought a Benelli 1130 3-cylinder motor as test mule.
It's an abandoned engine that was disassembled 8 years ago due to high oil consumption and then left in a dealers workshop.
Head is in pieces and a few parts are missing hence it will take some time before a first start will be feasible.

.

Would https://github.com/rusefi/rusefi-hardware/tree/main/breakout-boards/Breakout-24pin help?

This adapter will help a lot!
Thank you so much!!

I had to trip connector trim but overall it's probably good enough.

using a MRE ECU I currently understand that in addition the https://wiki.rusefi.com/rusEFI-Wideband-Controller/ will be required.
Is this correct understanding?

Emission standard to meet is Euro 3:
all measured in mg/km
CO , HC , NOx
2.000, 300 , 150

mi-hol wrote: ↑

Sat Feb 11, 2023 4:47 pm

Emission standard to meet is Euro 3:
all measured in mg/km
CO , HC , NOx
2.000, 300 , 150

Excuse me, what?! You've made a huge leap in your thought between rusEFI and emission standards

AndreyB wrote: ↑

Sat Feb 11, 2023 10:43 pm

huge leap in your thought between rusEFI and emission standards

well, it's the next logical step from "get it running" to "run it legally".
Vehicles in Germany require a technical inspection every 2 years to be performed by an independent and licensed test lab (TÜV).
Vehicles that fail this verification lose their license plate and approval for road traffic.

Therefore I need to consider this requirement now.

Adapter boards soldered and cases delivered