Page 4 of 4
Re: Ford Festiva / Protege / Miata motor (#3)
Posted: Tue Aug 15, 2017 11:27 pm
by AndreyB
Re: Ford Festiva / Protege / Miata motor (#3)
Posted: Thu Aug 17, 2017 12:53 am
by tigeryan
I posted over there, looks like there might be a few questions for you to answer....
Re: Ford Festiva / Protege / Miata motor (#3)
Posted: Wed Mar 14, 2018 12:16 pm
by hossein
I was trying to run another ford festiva - called pride here -, ignition was good but unfortunately injection and all settings about injection were not !
I'd tied to increase/decrease injection flow, injection base time, and other, and nothing has changed.
- I just run TS on my laptop with new installation of Linux. and i copied TS from my working machine.-
So how i can check whats wrong ? i mean what exactly is wrong here .
I'd shared trigger signal with another ecu - original ecu of car - injectors were working.
Is time or something else wrong ?
Thanks.
Re: Ford Festiva / Protege / Miata motor (#3)
Posted: Wed Mar 14, 2018 4:47 pm
by kb1gtt
Can you pull an injector and squirt in a container? Such that you verify your flow. Can you share crank signals with the oen ecu? Such that oem runs like 3 cyl while you tune only one cyl.
Re: Ford Festiva / Protege / Miata motor (#3)
Posted: Sun Feb 21, 2021 7:46 pm
by tigeryan
Need to migrate to fresh firmware maybe one day but right now attached is in the car.
Code: Select all
this section was generated automatically by ConfigDefinition.jar based on rusefi_config.txt Sat Feb 02 20:30:30 EST 2019