Page 1 of 1

one cylinder hf predator engine 212cc #54

Posted: Fri Oct 04, 2019 10:21 pm
by Abricos
hi :lol:
i have HF predator engine 212cc which was in the original carburetor ...
now it's converted to efi ... I connected a standard set of sensors ... MAP, CLT, IAT, ignition coil, fuel injector,fuel pump , fuel regulator,ETB,VR sensor ,36/1 trigger wheel ,electric starter ,cylinder pressure sensor, ECU RusEFI MRE ...
trigger wheel mounted as in the picture ... when piston in TDC position tooth #7 and VR sensor (in one line) ...
New Bitmap Image.bmp
New Bitmap Image.bmp (660.01 KiB) Viewed 25914 times
Now I need to make an ignition and fuel map ...
I found another my mistake ... my trigger wheel location on (power takeoff - the output shaft) and that means trigger wheel spinning Counterclockwise :( :( and that means right now all mirrored :(
IMG_20190906_230950.jpg
IMG_20190906_230950.jpg (2.32 MiB) Viewed 25914 times
but it should still work correctly????????????



IMG_20190927_192452.jpg
IMG_20190927_192452.jpg (2.6 MiB) Viewed 25914 times
IMG_20190925_171418.jpg
IMG_20190925_171418.jpg (2.06 MiB) Viewed 25914 times
IMG_20190919_202915.jpg
IMG_20190919_202915.jpg (2.7 MiB) Viewed 25914 times
IMG_20190919_202905.jpg
IMG_20190919_202905.jpg (2.79 MiB) Viewed 25914 times
IMG_20190916_163246.jpg
IMG_20190916_163246.jpg (1.41 MiB) Viewed 25914 times
IMG_20190915_210028.jpg
IMG_20190915_210028.jpg (2.8 MiB) Viewed 25914 times
IMG_20190911_191956.jpg
IMG_20190911_191956.jpg (1.81 MiB) Viewed 25914 times

Re: hf predator engine 212cc

Posted: Fri Oct 04, 2019 10:23 pm
by Abricos
2019-10-04_13_32_30_278rpm_0_maf_0.0.png
2019-10-04_13_32_30_278rpm_0_maf_0.0.png (40.53 KiB) Viewed 25913 times
2019-10-04_13_31_28_789rpm_0_maf_0.0.png
2019-10-04_13_31_28_789rpm_0_maf_0.0.png (23.24 KiB) Viewed 25913 times
MRE9.23.19.rar
(1.02 MiB) Downloaded 780 times

Re: hf predator engine 212cc

Posted: Sat Oct 05, 2019 12:52 am
by AndreyB
Engines are supposed to start if
1) fuel
2) spark
3) compression
?

Re: hf predator engine 212cc

Posted: Sat Oct 05, 2019 12:09 pm
by Abricos
russian wrote:
Sat Oct 05, 2019 12:52 am
Engines are supposed to start if
1) fuel
2) spark
3) compression
?
1.fuel Yes we have injectors spraying ( maybe not enough )
2. Spark yes
3. Compression good
the video shows smoke from the muffler ...and periodically shoots ...

Re: hf predator engine 212cc

Posted: Sat Oct 05, 2019 12:14 pm
by puff
I'd say ignition timing could be wrong?...
what are those red and green dashed lines? what's no_pin event in the bottom?

Re: hf predator engine 212cc

Posted: Sun Oct 06, 2019 1:14 am
by AndreyB


Even if you have sexy Yamaha R1 titanium exhaust on your harbor freight predator EFI - do not touch it!!!

Re: hf predator engine 212cc #54

Posted: Sun Oct 06, 2019 2:07 am
by kb1gtt
I like that as a moto. "rusEFI, don't touch your sexy exhaust" I think that be a great bumper sticker.

Re: hf predator engine 212cc #54

Posted: Thu Oct 24, 2019 10:37 pm
by Abricos
I installed the CAM sensor (Hall type)...
the sensor is powered by 6 volts ...(separate power source)
I make a couple of screenshots ...
I think that CAM sensor shows me the backward ...
or am I doing something wrong ...
in TS VVT position guage indicate 610 (what that mean ?)
2019-10-24_15_03_22_961rpm_0_maf_0.0.png
2019-10-24_15_03_22_961rpm_0_maf_0.0.png (23.38 KiB) Viewed 25764 times
2019-10-24_15_04_26_067rpm_0_maf_0.0.png
2019-10-24_15_04_26_067rpm_0_maf_0.0.png (25.33 KiB) Viewed 25764 times
New Bitmap Image.bmp
New Bitmap Image.bmp (3 MiB) Viewed 25764 times

Re: hf predator engine 212cc #54

Posted: Fri Oct 25, 2019 3:08 am
by AndreyB
Both images show only one VVT cycle. Would be nicer to see two or three cycles - to do that, please increase sniffer size on the bottom of the engine sniffer pane.

VVT input does not count like "cam" on our trigger page :( It's impossible to understand unfortunately but you need to say "4 stroke without cam"

Re: hf predator engine 212cc #54

Posted: Fri Oct 25, 2019 10:45 pm
by Abricos
i switched to 4 stroke without cam sensor
after switching (with and without cam sensor) rpm go double down
with cam 1285
without cam 628
and as I said a week ago after update MRE new bundle using ST-link ETB only work after type in console (set_rpn_expression 8 0)
New Bitmap Image (2).bmp
New Bitmap Image (2).bmp (3 MiB) Viewed 25737 times
New Bitmap Image (1).bmp
New Bitmap Image (1).bmp (3 MiB) Viewed 25737 times
2019-10-25_15_14_59_056rpm_0_maf_0.0.png
2019-10-25_15_14_59_056rpm_0_maf_0.0.png (22.44 KiB) Viewed 25737 times

Re: hf predator engine 212cc #54

Posted: Fri Oct 25, 2019 10:50 pm
by AndreyB
Maybe I should simply prohibit BMP pictures because this 3Mb size versus 30Kb images is just painful.

Looks like everything works as expected?

Re: hf predator engine 212cc #54

Posted: Wed Oct 30, 2019 10:11 pm
by Abricos
motor starter ...
works stably ...
motor start quick and easy ...
I am Little bit not understand why (trigger angle offset deg 280 )?
need to eliminate intake air leaks ...
MRE10.30.19.rar
(1.67 MiB) Downloaded 750 times
my religious canons say bmp format big and good ...
New Bitmap Image (3).bmp
New Bitmap Image (3).bmp (3 MiB) Viewed 25704 times

Re: hf predator engine 212cc #54

Posted: Sat Nov 09, 2019 7:05 pm
by AndreyB
Pics of pressure sensor installation

Re: one cylinder hf predator engine 212cc #54

Posted: Sun Dec 22, 2019 7:14 pm
by AndreyB
Nick is trying another approach to combine spark plug with pressure sensor glow plug.

Re: one cylinder hf predator engine 212cc #54

Posted: Sun Dec 22, 2019 7:16 pm
by AndreyB
Taking smaller spark plugs apart is part of this project. @andreika has pointed us at 10mm and even 8mm thread size spark plugs, see Image

Re: one cylinder hf predator engine 212cc #54

Posted: Thu Mar 12, 2020 2:24 pm
by Abricos
Old video

Re: one cylinder hf predator engine 212cc #54

Posted: Tue May 26, 2020 10:52 pm
by Abricos
hi
Today I had a small incident :D
chip marked TLE8888 blew magic smoke but continued to work stably ...
the only problem is the fuel pump is constantly working when you turn on the ignition ...
roughly burnt pins on Tle8888 BATPA,OUT23,OUT22 from 48 pin connector pin 33 (GP out 3 )
maybe I did something wrong with connecting the generator or this is the first version of the MRE board ...
IMG_20200526_172956.jpg
IMG_20200526_172956.jpg (4.91 MiB) Viewed 20598 times
IMG_20200526_172953.jpg
IMG_20200526_172953.jpg (4.07 MiB) Viewed 20598 times
IMG_20200526_181745.jpg
IMG_20200526_181745.jpg (3.29 MiB) Viewed 20598 times
IMG_20200526_181323.jpg
IMG_20200526_181323.jpg (4.54 MiB) Viewed 20598 times
IMG_20200526_181141.jpg
IMG_20200526_181141.jpg (3.2 MiB) Viewed 20598 times

Re: one cylinder hf predator engine 212cc #54

Posted: Tue May 26, 2020 11:21 pm
by kb1gtt
Hand crafted chip. Cool to see how it still works.