A breakout board for Chrysler NGC connector.
https://svn.code.sf.net/p/rusefi/code/trunk/hardware/NGC_38_connector/
Case: https://www.tinkercad.com/things/dwXC24Jn2AG-single-ngc-38-box-v03
Order from Oshpark
[info] NGC 38 pin connector
- AndreyB
- Site Admin
- Posts: 14381
- Joined: Wed Aug 28, 2013 1:28 am
- Location: Jersey City
- Github Username: rusefillc
- Slack: Andrey B
NGC 38 pin connector
Very limited telepathic abilities - please post logs & tunes where appropriate - http://rusefi.com/s/questions
Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
- AndreyB
- Site Admin
- Posts: 14381
- Joined: Wed Aug 28, 2013 1:28 am
- Location: Jersey City
- Github Username: rusefillc
- Slack: Andrey B
Re: NGC 38 pin connector
the board is too tall this makes the shell for it HUGE https://tinkercad.com/things/fKZ8OSqr5zQ-38-draft-3
I guess we do not really need two holes for each wire, one would be enough. If we center the board and shrink it by 6mm on each side things should get smaller.
I guess we do not really need two holes for each wire, one would be enough. If we center the board and shrink it by 6mm on each side things should get smaller.
- Attachments
-
- 38pin_case[1].jpg (819.88 KiB) Viewed 3588 times
Very limited telepathic abilities - please post logs & tunes where appropriate - http://rusefi.com/s/questions
Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute