[info] Proteus - Waterproof, High-feature ECU!

[Abricos]

I have EGT ...
I use EGT ...

[Lambo97]

Interesting, Soon we will be able to run Pulsejet or Turbine with Rus EFI!

[JRD McLAREN]

Interesting, Soon we will be able to run Pulsejet or Turbine with Rus EFI!

Contact Colin Furze ...

[AndreyB]

Latest eBay policy prohibits standalone ECUs so no more eBay listing for us. At the moment all sales are via private messages, will add some store maybe later.

[puff]

wtf?? is there any rationale behind that decision by eBay?

[Simon@FutureProof]

Banning all "emissions defeat devices" basically.

Seems to be ebay.com only

[Abricos]

Banning all "emissions defeat devices" basically.

Seems to be ebay.com only

But VAG TDI ECU still for sale on ebay ...))))

[AndreyB]

Available for sale https://shop.rusefi.com/

[subzero]

can i use stm32f407zgt6 or i need stm32f429?

[AndreyB]

can i use stm32f407zgt6 or i need stm32f429?

no stm32f407zgt6

https://github.com/rusefi/rusefi/wiki/Chip-Shortage-Parts-Interchange says "256KB RAM required" which stm32f407zgt6 is not

[kneelo]

Finally installed my v0.3 in my latest track car (Holden VE commodore with the LEO Alloytec HFV6). Car starts and runs... yay!

There are a few errors on the online pinout diagram for the 23pin connector I found in the process of getting it working. The main one is that pin 14 is listed as a gnd but is actually one of the usb comms lines. I was losing Usb whenever this plug was connected until I checked the schematic.

There was a couple of other pins that were also wrong related to usb signals on this connector, I think maybe these were marked as the canbus lines on the pinout from memory. I assume there has been a hardware change at some point between versions.

Also is there a summary anywhere of the hardware mods required to get the knock sensing working? If chip availability wasnt an issue I would probably just go with a new board. As it is Im thinking I might try and kludge this board.

[AndreyB]

There are a few errors on the online pinout diagram for the 23pin connector I found in the process of getting it working. The main one is that pin 14 is listed as a gnd but is actually one of the usb comms lines. I was losing Usb whenever this plug was connected until I checked the schematic.

You would not believe it - https://github.com/mck1117/proteus/blob/master/changelog.md was created about a week ago

I've just mentioned USB removal on the changelog.

[subzero]

Just a question bought for my w201 2.3 8v denso honda hall sensor that needs 12 volt and outpouts 12 volt square signal
Proteus can accept 12 volt digital input for rpm signal?

[AndreyB]

Yes digital inputs are 12v tolerant when official parts were soldered.

This unit has taken liberty with connector color hopefully nothing else, we do not know how exactly your unit was assembled.

[subzero]

usen pcb prepopulated from jlcpcb and hand solderes high side low side drivers and stm.Used official bom

[AndreyB]

usen pcb prepopulated from jlcpcb and hand solderes high side low side drivers and stm.Used official bom

my bad - it is in fact a white connector on the bottom. I am probably confusing with unrelated batch of units. Plz start a build thread?