CAN BUS Gauges
Posted: Mon Jul 06, 2020 8:27 pm
Has anyone tried using Freedom CAN BUS gauges with Frankenso? If so, issues? Results? 
Page 1 of 1
Re: CAN BUS Gauges
Posted: Mon Jul 06, 2020 8:35 pm
I don't think anybody has tried, but if they specify what CAN messages are required, we can easily add a preset for it.
Re: CAN BUS Gauges
Posted: Mon Jul 06, 2020 8:36 pm
Oh, it looks like they use standard J1979 (OBD2) messages, which we already support. There's a good chance they'll work out of the box without any firmware changes.
Re: CAN BUS Gauges
Posted: Mon Jul 06, 2020 9:11 pm
Excellent!
I will test them when I get my board assembled. Can I run my frankenso on the Bench to try them ?Re: CAN BUS Gauges
Posted: Mon Jul 06, 2020 9:57 pm
Yep, CAN should work fine on the bench.
Re: CAN BUS Gauges
Posted: Mon Jul 27, 2020 12:17 pm
