Hi all.
I would like to grab some values from rusEFI to print on my display. do I need to send a request or can I just listen in? what nitrate and stuff should I use?
cheers
[help needed] Grabbing values over CanBus
Re: Grabbing values over CanBus
which exactly?
Re: Grabbing values over CanBus
I would like to read vvt position on my display and (if it's doable) receive map from gpio (akthough mpx4250s are quite cheap so no biggie)
the other alternative is to send serial commands and read in what comes back - not sure what the command is on rusefi though .
the other alternative is to send serial commands and read in what comes back - not sure what the command is on rusefi though .
Re: Grabbing values over CanBus
ok I have found the obd2 stuff so I'll have a read. looks like there are only a few pids but good exercise to read those I guess
- AndreyB
- Site Admin
- Posts: 14333
- Joined: Wed Aug 28, 2013 1:28 am
- Location: Jersey City
- Github Username: rusefillc
- Slack: Andrey B
Re: Grabbing values over CanBus
CAN support is a bit experimental and limited. As for serial port see https://github.com/rusefi/rusefi/blob/master/firmware/console/binary/tunerstudio.cpp
Very limited telepathic abilities - please post logs & tunes where appropriate - http://rusefi.com/s/questions
Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
Always looking for C/C++/Java/PHP developers! Please help us see https://rusefi.com/s/howtocontribute
Re: Grabbing values over CanBus
Thats great. seem to be returning some values sending an 'O' ill let you know how it goes.