rusefi.com

Hello all, New to this forum and RUSefi.

I have been looking through the getting started threads, and I think i have managed to at least load the correct .bin file to the board:

C:\Users\joey1\Desktop\snapshot_20200522_014232_stm32f767_nucleo_rusefi

using the STM32 ST-LINK Utility.

Once it programmed, I got a rapidly blinking blue LED on the board, witch i think is a good thing.

The board shows up as an ST link virtual com in my device manager.
Where i am stuck now is establishing and sort of serial comms with the board.
I have tried Putty, Real Term, Arduino Serial monitor, TunerStudio, and RUsefi console.

The port shown up ( as 27 in my case ) and I set it to 115200 baud, however i cant seem to get anything from the Nucleo. Wondering what i might be doing wrong?

Thanks





.

there are two connectors on that board, top for programming and bottom for communication. which one are you connecting two?

please post a picture of device manager

there are two connectors on that board, top for programming and bottom for communication. which one are you connecting two?

please post a picture of device manager

AndreyB, thank you for the quick reply.

I tried both, but i did get it communicating finally! turns out I had not 1, but 2 faulty usb cables. once I swapped them around everything seems to be working fine.

again, thanks, and thus far RusEfi looks to be a beast of a system.