Cranking Settings -> Advanced -> Flood clear

It's all about the code!
Post Reply
tmbryhn
Posts: 169
Joined: Wed Feb 12, 2020 2:40 am
Location: Norway

Cranking Settings -> Advanced -> Flood clear

Post by tmbryhn »

Enable Flood clear: True or false.

On an ETB setup, is this based on the TPS or PPS input?
If TPS based, this could be problematic if the "Maximum ETB position (%)" or "ETB Pedal Target" relationship is defined/mapped such that the TPS would never reach >95% opening while in the cranking RPM zone.

Regardless of TPS or PPS based logic; would it make sense to instead have a setting that would let the user define which TPS threshold would activate flood clear, eg. fuel cut-off while RPM < "Cranking RPM limit" instead of having the fixed 95% threshold?
mck1117
running engine in first post
running engine in first post
Posts: 1493
Joined: Mon Jan 30, 2017 2:05 am
Location: Seattle-ish

Re: Cranking Settings -> Advanced -> Flood clear

Post by mck1117 »

image.png
image.png (71.04 KiB) Viewed 1793 times
It checks against our synthetic "driver throttle intent" channel. In case of cable throttle it uses TPS, in case of electronic throttle it uses the pedal.
tmbryhn
Posts: 169
Joined: Wed Feb 12, 2020 2:40 am
Location: Norway

Re: Cranking Settings -> Advanced -> Flood clear

Post by tmbryhn »

To be clear; is the threshold still 95% pedal input in ETB mode for activating flood clear?
mck1117
running engine in first post
running engine in first post
Posts: 1493
Joined: Mon Jan 30, 2017 2:05 am
Location: Seattle-ish

Re: Cranking Settings -> Advanced -> Flood clear

Post by mck1117 »

Affirmative.
Post Reply