CAN BUS Gauges
-
- Posts: 17
- Joined: Fri Jan 13, 2017 2:35 am
CAN BUS Gauges
Has anyone tried using Freedom CAN BUS gauges with Frankenso? If so, issues? Results?
-
- running engine in first post
- Posts: 1494
- Joined: Mon Jan 30, 2017 2:05 am
- Location: Seattle-ish
Re: CAN BUS Gauges
I don't think anybody has tried, but if they specify what CAN messages are required, we can easily add a preset for it.
-
- running engine in first post
- Posts: 1494
- Joined: Mon Jan 30, 2017 2:05 am
- Location: Seattle-ish
Re: CAN BUS Gauges
Oh, it looks like they use standard J1979 (OBD2) messages, which we already support. There's a good chance they'll work out of the box without any firmware changes.
-
- Posts: 17
- Joined: Fri Jan 13, 2017 2:35 am
Re: CAN BUS Gauges
Excellent! I will test them when I get my board assembled. Can I run my frankenso on the Bench to try them ?
-
- running engine in first post
- Posts: 1494
- Joined: Mon Jan 30, 2017 2:05 am
- Location: Seattle-ish
Re: CAN BUS Gauges
Yep, CAN should work fine on the bench.
-
- Posts: 17
- Joined: Fri Jan 13, 2017 2:35 am