Difference between revisions of "Manual:Debug fields"

From rusEfi
Jump to navigation Jump to search
Line 20: Line 20:
 
| 0
 
| 0
 
| Alternator_PID
 
| Alternator_PID
| duty cycle
+
| controller output
 
| integration term
 
| integration term
 
| previous error
 
| previous error
Line 59: Line 59:
 
| 3
 
| 3
 
| Idle
 
| Idle
| previous result
+
| controller output
 
| integration term
 
| integration term
 
| previous error
 
| previous error
Line 111: Line 111:
 
| 7
 
| 7
 
| Aux PID #1
 
| Aux PID #1
| previous result
+
| controller output
 
| integration term
 
| integration term
 
| previous error
 
| previous error

Revision as of 18:45, 12 March 2019

Debug fields is an advanced troubleshooting feature allowing one to monitor internal state of some rusEfi subsystems. In an ideal world we would be always saving all these data points, in reality we need to only save those while troubleshooting something specific.

set debug_mode CODE


code name debug f1 debug f2 debug f3 debug f4 debug f5 debug f6 debug f7 debug i1 debug i2 debug i3
0 Alternator_PID controller output integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
1 TPS acceleration from TPS to TPS current TPS<>TPS value extra fuel
2 Warmup PID
3 Idle controller output integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
4 Engine load acceleration
5 Trigger Counters channel #1 rise counter channel #2 rise counter channel #3 rise counter channel #1 fall counter channel #2 fall counter channel #3 fall counter
6 FSIO ADC
7 Aux PID #1 controller output integration term previous error I setting D setting dTerm
8 VVT position VVT event counter
9 Cranking cycles from start counter
11 short-term closed loop fuel PID integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
12 VSS vss event counter
17 ETB electronic throttle body PID duty cycle integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
21 ADC VBatt TPS MAF MAP CLT IAT EGO
23 FSIO_EXPRESSION FSIO output #1 FSIO output #2 FSIO output #3 FSIO output #4 FSIO output #5 FSIO output #6
24 Status Seconds since reboot VCS_VERSION
25 CJ125 Heater Duty Heater PID I Term Heater PID Err UA UR Calibr.UA Calibr.UR State Diag.reg
26 CAN read counter write OK write NOT ok


1-Base_Engine_Settings.png

Debug gauges.png