Difference between revisions of "Manual:Debug fields"

From rusEfi
Jump to navigation Jump to search
m
Line 111: Line 111:
 
| 7
 
| 7
 
| Aux PID #1
 
| Aux PID #1
|  
+
| previous result
|  
+
| integration term
|  
+
| previous error
|  
+
| I setting
|  
+
| D setting
|  
+
| dTerm
 
|  
 
|  
 
|  
 
|  
Line 131: Line 131:
 
|  
 
|  
 
|  
 
|  
|  
+
| VVT event counter
 
|  
 
|  
 
|  
 
|  

Revision as of 06:24, 14 August 2018

Debug fields is an advanced troubleshooting feature allowing one to monitor internal state of some rusEfi subsystems. In an ideal world we would be always saving all these data points, in reality we need to only save those while troubleshooting something specific.

set debug_mode CODE


code name debug f1 debug f2 debug f3 debug f4 debug f5 debug f6 debug f7 debug i1 debug i2 debug i3
0 Alternator_PID duty cycle integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
1 TPS acceleration from TPS to TPS current TPS<>TPS value extra fuel
2 Warmup PID
3 Idle previous result integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
4 Engine load acceleration
5 Trigger Counters channel #1 rise counter channel #2 rise counter channel #3 rise counter channel #1 fall counter channel #2 fall counter channel #3 fall counter
6 FSIO ADC
7 Aux PID #1 previous result integration term previous error I setting D setting dTerm
8 VVT position VVT event counter
9 Cranking cycles from start counter
11 short-term closed loop fuel PID integration term previous error I setting D setting dTerm maxValue P setting offset settings change counter
12 VSS vss event counter
21 ADC VBatt TPS MAF MAP CLT IAT EGO
23 FSIO_EXPRESSION FSIO output #1 FSIO output #2 FSIO output #3 FSIO output #4 FSIO output #5 FSIO output #6
24 Status Seconds since reboot VCS_VERSION
25 CJ125 Heater Duty Heater PID I Term Heater PID Err UA UR Calibr.UA Calibr.UR State Diag.reg
26 CAN read counter write OK write NOT ok


1-Base_Engine_Settings.png

Debug gauges.png