Manual:Software

From rusEfi
Jump to: navigation, search
This page is a translated version of the page Manual:Software and the translation is 62% complete.

Other languages:
English • ‎русский
Нажмите для перехода к ресурсам для разработчика

Для начала, по получении главной платы её нужно 'прошить' rusEfi 'бинарником' - см. тут (англ).


st_link_utility.png

После прошивки главной платы вы можете подключиться к ней используя нашу java-консоль, TunerStudio или любой терминал, например Putty.



On the picture below the black mini-USB cable is used to power & program the board, the orange micro-USB cable is used for communication and the yellow jumper wire sends the simulated trigger signal back into the board. discovery_and_wires.jpg



First thing you might want to do once you connect to the firmware via the dev console or terminal would be setting your engine type.
Once you set your engine type, you might be interested in jumping the "1 EMULATION" pin to the "TRIGGER IN 1" as defined in the pinout and enjoy some cyan wares in the "Digital Sniffer" tab of the java dev console.


java_console_2.png