stm32f7xx_hal_conf.h File Reference

Detailed Description

HAL configuration file.

Attention

© COPYRIGHT(c) 2019 STMicroelectronics

Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met:

1. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution.
3. Neither the name of STMicroelectronics nor the names of its contributors may be used to endorse or promote products derived from this software without specific prior written permission.

THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

Definition in file stm32f7xx_hal_conf.h.

Variables
	C

Variable Documentation

C

C

extern

Value of the Internal Low Speed oscillator in Hz The real value may vary depending on the variations in voltage and temperature.
Value of VDD in mv tick interrupt priority Transceiver Basic Control Register
Transceiver Basic Status Register
PHY Reset Select loop-back mode Set the full-duplex mode at 100 Mb/s Set the half-duplex mode at 100 Mb/s Set the full-duplex mode at 10 Mb/s
Set the half-duplex mode at 10 Mb/s
Enable auto-negotiation function
Restart auto-negotiation function
Select the power down mode
Isolate PHY from MII
Auto-Negotiation process completed
Valid link established
Jabber condition detected
PHY status register Offset
PHY Speed mask
PHY Duplex mask
PHY Interrupt Source Flag register Offset
PHY Link down inturrupt

Go to the source code of this file.