mega-uaefi.h File Reference

Functions
void	setMegaUaefiBoardDefaultConfiguration ()
void	setMegaUaefiBoardConfigOverrides ()

Function Documentation

setMegaUaefiBoardConfigOverrides()

void setMegaUaefiBoardConfigOverrides

(

)

Definition at line 8 of file mega-uaefi.cpp.

                                        {
    setHellenMegaEnPin();
    setHellenVbatt();
 
    engineConfiguration->vrThreshold[0].pin = Gpio::MM100_OUT_PWM6;
 
    hellenMegaAccelerometerPreInitCS2Pin();
  engineConfiguration->isSdCardEnabled = true;
  engineConfiguration->sdCardCsPin = Gpio::H_SPI1_CS1;
    engineConfiguration->sdCardSpiDevice = SPI_DEVICE_1;
    engineConfiguration->spi1mosiPin = Gpio::A7; // not the usual H_SPI1_MOSI since that's CAN2RX
    engineConfiguration->spi1misoPin = Gpio::H_SPI1_MISO;
    engineConfiguration->spi1sckPin = Gpio::H_SPI1_SCK;
    engineConfiguration->is_enabled_spi_1 = true;
    setDefaultHellenAtPullUps();
 
    engineConfiguration->canTxPin = Gpio::B13;
    engineConfiguration->canRxPin = Gpio::B5;
}

Referenced by setup_custom_board_overrides().

Here is the call graph for this function:

Here is the caller graph for this function:

setMegaUaefiBoardDefaultConfiguration()

void setMegaUaefiBoardDefaultConfiguration

(

)

Definition at line 28 of file mega-uaefi.cpp.

                                             {
    // GM stepper: DC2 positive#4/negative#5 to pins A/B
  // DC1 positive#1/negative#2 to pin D/C
  setupTLE9201IncludingStepper(/*PWM controlPin*/Gpio::MM100_OUT_PWM3, Gpio::MM100_OUT_PWM4, Gpio::MM100_SPI2_MISO);
  setupTLE9201IncludingStepper(/*PWM controlPin*/Gpio::MM100_OUT_PWM5, Gpio::MM100_SPI2_MOSI, Gpio::MM100_USB1ID, 1);
 
  setHellenMMbaro();
}

Referenced by uaefi_121boardDefaultConfiguration().

Here is the call graph for this function:

Here is the caller graph for this function:

Go to the source code of this file.